Pyramid Sinker Mold with 5 Cavities for Freshwater and Saltwater Fishing

When making sinkers, it is crucial to wear protective clothing and exercise caution when heating and pouring lead. Ensure that all necessary safety measures are taken, as lead is a toxic material. Use appropriate personal protective equipment (PPE) when handling the molds, and be mindful of the potential dangers involved.

Begin by placing scrap lead into a saucepan and heating it until it becomes molten, which typically occurs at around 650 degrees. Once the lead has melted, use a cooking spoon to remove any impurities that have risen to the top. If you are making sinkers that require a hole in the center, take your coat hanger wire and place it within the mold.

It is recommended that the mold be preheated before use. This will help ensure that the molten lead flows smoothly into the cavity. Once the mold has been heated and your lead is fully molten and clean, you can proceed to pour the lead into the cavity.

Carefully grab the mold with tongs, ensuring that the pouring cavity is facing you. Slowly and steadily, pour the molten lead into the mold until the cavity is completely filled. Wait approximately 10 seconds, then use pliers to pull the wire out, if present. Proceed to open the mold.

Using your pliers, snip off any excess lead from the top of the sinkers. This will help create a clean, finished product. Remember to always take care when working with lead, as it is a toxic material.

When disposing of unwanted lead, it is important to consult your local authority about the appropriate methods. Some municipalities may have specific guidelines or regulations regarding the disposal of hazardous materials like lead.

In summary, the steps to make sinkers are as follows:

1. Ensure you are wearing protective clothing and take all necessary precautions when heating and pouring lead.
2. Melt the scrap lead in a saucepan until it becomes molten.
3. Use a cooking spoon to remove any impurities that have risen to the surface.
4. If making sinkers with a center hole, place the coat hanger wire in the mold.
5. Preheat the mold before use.
6. Carefully pour the molten lead into the mold's cavity.
7. Wait 10 seconds, then use pliers to remove the wire (if present) and open the mold.
8. Snip off any excess lead from the top of the sinkers.
9. Properly dispose of any unwanted lead according to local authority guidelines.

Remember, safety should always be the top priority when working with lead. Take all necessary precautions to protect yourself and the environment.

product information: